You are here: Reference for Processing Blocks and Controls > DSP Processing Blocks > Conferencing > Conferencing Room Processor Selector

Block Reference

Conference Room Processor Selector Block

The Conference Room Processor Selector block provides the ability to select one of the available Distributed Program Bus channels. The block contains a Selector control that you can link to a remote device, giving end users the ability to select the input they want. Properties for this block are the same as the standalone Selector block except that the available input channels are provided by the Distributed program Bus and do not need to be wired. The selected channel is available to be mixed into the far-end signal via the To Far End Mixer and into room outputs via the Room Matrix Mixer.

See: Introduction to Conferencing

Room Processor Properties (Selector Block)

To access this block, locate the relevant Conference Room Combine processor block on your Processing Map and open its properties. Click the Room Processors tab. Locate the relevant Room Processor block and open its properties. This Selector block, which is a child block of the Room Processor block, appears as shown above. From here, you can open the Selector block properties by double-clicking the block or hovering and clicking the properties icon that appears in the upper right of the block's title bar.

note: The signal path through the block is pre-wired and cannot be changed.

For more details, see the Conference Room Processor Block and Conference Room Combine.