A RAD Line Input block represents the audio signal received from this output channel on the RAD connected to the corresponding RAD port on the HAL or EXP device.
note: A RAD does not appear in the I/O palette until it has been added to the system in the Hardware Workspace.
|Analog Input (Channel 1)||The input channel on the RAD connected to the corresponding RAD port on the HAL or EXP device|
|Output node||Connection point for wiring the RAD's input audio to another block's input|
Gain (Manual and Linkable Control)
Gain (both a manual and linkable control) sets the volume of the block's output. Also specified is the volume range with a Minimum and Maximum value. Change the volume by adjusting the slider or entering a dB value in the edit box. Provide end users with control over the volume by linking this Level Control to the Level Control of a DR1 or DR3. Change the range by clicking the Minimum or Maximum value and then typing new values in the edit box that appears. The meters display signal data before and after passing through the Level settings.
Default Gain = 0.0 dB; Default Minimum = -88.0; Default Maximum = 12.0
|Off @ Min Checkbox||When checked, causes the audio to mute completely when dialed to the low end of its range.|
|Mute (Manual and Linkable Control)||Mute the block's output without changing the Gain value. Provide end users with output mute control by linking this Toggle Control to the Toggle Control of a DR2, DR3, or Logic In port.|