You are here: Reference for Processing Blocks and Controls > DSP Processing Blocks > Paging/Room Combine > Zone Processor Priority Selector

Block Reference

Zone Processor Priority Selector Block

Using the Zone Processor Priority Selector block, you can work with the zone's input sources and configure up to three priority detectors. This block is almost identical to the standalone Priority Selector block. The only difference is the inclusion of the Distributed Program Bus inputs.

Zone Processor Priority Selector

To access this block, locate a Zone Processor block on your Processing Map and open its properties. This Priority Selector block, which is a child block of the Zone Processor block, appears. From here, you can open the Priority Selector block properties by double-clicking the block or hovering and clicking the properties icon that appears in the upper right of the block's title bar.

note: The signal path through the block is pre-wired and cannot be changed.

For more details, see the Zone Processor Block and About Zone Processing.

See Also